| Step | | Procedure & Parts & Tools |
| 1 |
|
REMOVE THE CAPS TO DRAIN THE TANKS
|
| 2 |
|
PULL TO REMOVE THE RED CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 3 |
|
PULL TO REMOVE THE BLUE CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 4 |
|
REMOVE THE 2 TANK BOLTS ON EACH SIDE OF THE MACHINE. THESE BOLTS ARE LOCATED AT THE FRONT OF THE MACHINE AT THE BASE.
|
| 5 |
|
LIFT THE TANK TO OPEN THE MACHINE TO LOCATE BATTERIES
|
| 6 |
|
REMOVE THE BATTERIES FROM THE MACHINE
|
| 7 |
|
LAY THE MACHINE ON ITS SIDE
|
| 8 |
|
LOOSEN THE WHEEL BOLT
| Ratchet-Socket metric 13mm |
|
|
| 9 |
|
PULL TO REMOVE THE BOLT FROM THE WHEEL
|
| 10 |
|
PULL THE WHEEL OFF THE AXLE
|
| 11 |
|
LOOSEN BRUSH LINKAGE BOLT
| Ratchet-Socket metric 13mm |
|
|
| 12 |
|
PULL TO REMOVE THE BOLT FROM THE LINKAGE
|
| 13 |
|
LOOSEN THE BRUSH LINKAGE NUT
| Ratchet-Socket metric 13mm |
|
|
| 14 |
|
PULL TO REMOVE THE WASHER AND NUT FROM THE LINKAGE
|
| 15 |
|
SLIDE THE FOOT PEDAL BRUSH LINKAGE THRU THE MACHINE
|
| 16 |
|
REMOVE THE 2 BOLTS FROM EACH SIDE OF THE WHEEL AXLE.
| Torx T30 |
|
|
| 17 |
|
PULL TO REMOVE THE AXLE FROM THE MACHINE
|
| 18 |
|
REMOVE THE SNAP RING FROM THE BRUSH ARM AXLE
| Pliers |
|
|
| 19 |
|
LOOSEN BRUSH LINKAGE BOLT
| Crescent wrench |
|
|
| 20 |
|
PULL TO REMOVE BRUSH LINKAGE BOLT
|
| 21 |
|
PULL TO REMOVE BRUSH LINKAGE FROM MACHINE
|
| 22 |
|
LOOSEN LOCK NUT ON LOCKING LEVER
| Wrench-metric 10mm |
|
|
| 23 |
|
REMOVE LOCK NUT ON LOCKING LEVER
|
| 24 |
|
PULL UP ON THE PLASTIC LOCKING LEVER AND METAL LEVER TO REMOVE THEM FROM THE BOLT
|
| 25 |
|
LOCATE THE E-CLIP IN THE BATTERY COMPARTMENT AND USING PLIERS PULL E-CLIP FROM MACHINE
| Pliers-needle nose |
|
|
| 26 |
|
E-CLIP PULLED FROM MACHINE
|
| 27 |
|
REPEAT STEPS 11 THRU 21 TO REPLACE BRUSH LINKAGE ON OTHER SIDE OF MACHINE IF NEEDED
|
| 28 |
|
REVERSE STEPS 4 THRU 26 TO REASSEMBLE MACHINE. INSTALL NEW BRUSH LINKAGE
|